Motorcycles now have a wider range of accessories than ever before you can get practically any accessory you want for your motorcycle. You always have to check that your motorcycle can manage what ever accessory you add to it because if you add an accessory that your motorcycle can’t handle then it can cause damage to your bike. Some of the accessories you can get for your motorcycle are;

• Indicators
• Rear lights and head lights
• Saddle bags
• Speedometer
• Bolts
• Handle bars

As well as these kinds of accessories you can also make your own accessories that make your ride more comfortable such as toe rests. Which are a sheet of metal that sits adjacent to the foot peg allowing your feet to sit more comfortably, these are used quite a lot by those that spend long periods of time on their motorcycles.

There are also more technical products that you can use with your motorcycle such as an intercom system with radios linking a group of people together or you can get individual headsets that make it possible to have a radio system that runs through the head sets alone and can sit comfortably under your helmet. Along with these kinds of products you can get systems such as GPS and satellite radios.

A popular accessory to add to a motorcycle is heated grips to your handle bars and it’s a fairly easy process to complete if you know what you are doing, because they require wiring you will need to be entirely sure of what you are doing before attempting it. Here are some simple steps you can follow to wire them up to your bikes handles:

• The first thing you need to do is remove the grips you have in place at the moment this is a lot easier if you have some compressed air to help you slide them off. Once off you can start deciding where you want your switches and heating elements to go before starting to fit them.
• You need to make sure any glue that was left on the handle bars has been removed. Then the elements have a sticky back so all you have to do is remove the back stick them to the handle bars making sure the wire faces the centre of the bike as that is where the switch should be attached. Also you can secure the end by the wire with electrical tape so it can’t move and in turn damage the heating element.
• When you have these in place you need to link them together and set up the switch to the grips and battery. Make sure you have enough slack on the throttle side to allow the full throttle movement with out causing any tension.
• You then need to follow the instructions that come with your particular set to wire up your switch and handle cables to the battery. Once you have them wired up you can test them to ensure no connections have failed, most of these heaters get warm with in around three minutes.

You can find much more detail on various accessories either online or at your local motorbike shop.